Sesli çeviri, çevrimdışı özellikler, eşanlamlılar, fiil çekimi, öğrenme oyunları
Reklam
Ücretsiz kaydol: daha fazla sonuç ve özelliğe eriş
command execution processing microcomputer
"command execution processing microcomputer" metninin Çince çevirisi
命令执行处理微机
If non-simultaneous command 2 arrives during the timing period when non-simultaneous command 1 is being executed, the command execution processing microcomputer 14 interrupts the execution of non-simultaneous command 1 and issues a reject signal 1 corresponding to this command.
当非同时命令1正在执行时，如果在这一定时周期非同时信号2到达，则命令执行处理微机14中断非同时命令1的执行，并相应于这一信号发出拒绝信号1。
When the command selection communication control microcomputer 13 and command execution processing microcomputer 14 do not communicate, as in the case when a plurality of non-simultaneous commands reaches the VTR 12, the command to be actually executed is selected by the command selection communication control microcomputer 13 to be the most recently received non-simultaneous command.
当该命令选择通信控制微机13和命令执行处理微机14不通信时，如在本例中当多个非同时命令到达VTR12时，由命令选择通信控制微机13选择最近收到的非同时命令为实际执行的命令。
FIG. 5 illustrates a command selection communication control microcomputer 13 and the command execution processing microcomputer 14 of terminal 12, which may comprise a VTR.
图5表示终端12的一个命令选择通信控制微机13和一个命令执行处理微机14，该终端12可以包括一个VTR。
The communication between the command selection communication control microcomputer 13 and the command execution processing microcomputer 14 is performed during a predetermined timing period (about 17 msec) in the VTR.
在一个预定的时间周期（约17mS），在VTR中的命令选择通信控制微机13与命令执行处理微机14之间进行通信。
The command selection communication control microcomputer 13 and command execution processing microcomputer 14 perform the transmission and reception of the commands and the responses during the predetermined timing period of the command execution processing microcomputer 14.
命令选择通信控制微机13和命令执行处理微机14在命令执行处理微机14的预定定时期间执行命令和响应的发送及接收。
At the end of the timing period of the command execution processing microcomputer 14, non-simultaneous command 1 is sent to the command execution processing microcomputer 14 and a busy signal corresponding to this command is sent to terminal 11.
在命令执行处理微机14定时周期结束时，非同时命令1被送至命令执行处理微机14，并且相应于该命令的占线信号被送给终端11。
This selected command is then supplied at a subsequent communication timing to command execution processing microcomputer 14.
然后这个选出的命令在下一个通信定时被加至通信执行处理微机14。
Günün Kelimesi ve İfadesi
Günün Görseli
Sonuçlar: 7. Birebir: 7. Geçen süre: 7 ms.
