Play mode differs from the Setup Menu selection.
Die Einstellungen bei der Wiedergabe entsprechen nicht der Auswahl im Setup-Menü.
The Setup Menu mode is enabled in the default settings of the KVM switch.
In der Standardeinstellung des KVM-Switches ist der Modus Setup-Menü aktiv.
If the Configuration Setup Menu does not appear after repeated pressings of Ctrl+S, you were likely not fast enough.
Wenn das Konfigurationsmenü nach wiederholtem Tastendruck von "Strg+S" nicht erscheint, waren Sie vermutlich nicht schnell genug.
While in the Configuration Setup Menu, you can restore the prompt message as follows
Im Konfigurationsmenü können Sie die Eingabeaufforderungsmeldung wie folgt wiederherstellen
Select Tab 3 of the Setup Menu using the horizontal buttons of the control button
Rufen Sie mit den horizontalen Pfeiltasten der Steuertaste Seite 3 des Einstellungsmenüs auf.
Press the MENU button to display 3 of the Setup Menu, using the control button.
Drücken Sie die MENU-Taste und rufen Sie mit der Steuertaste Seite 3 des Einstellungsmenüs auf.
If you select Enabled, the Ctrl+S setup prompt appears after POST so that you can press Ctrl+S within the number of seconds allowed by the Setup Menu Wait Time -
Wenn Sie Aktiviert wählen, wird die Setup-Aufforderung "Strg+S" im Anschluss an POST angezeigt, so dass Sie innerhalb der als Wartezeit beim Setup-Menü - > eingestellten Sekundenanzahl "Strg+S" drücken können
Instructs you how to enter the Configuration Setup Menu.
Erklärt Ihnen, wie Sie in das Konfigurationsmenü gelangen.
Memory Stick functions for saving the System Menu and Setup Menu
Turn the Light Sensor setting to On in the Setup Menu.
Schalten Sie die Lichtsensor-Einstellung auf Ein im Setup-Menü.
Change the Power Saving setting to Low or High in the Setup Menu.
Ändern Sie die Energiesparmodus-Einstellung auf Niedrig oder Hoch im Setup-Menü.
Setup Screen Navigation To entry the Setup Menu, press and hold the Setup key until "CODE SETUP" appears in the display.
Navigation durch den Setup-Bildschirm Sie rufen das Setup-Menü auf, indem Sie die Setup-Taste drücken und gedrückt halten bis im Display „CODE SETUP" erscheint.