Faulty or improperly connected hard drive interface cable
Diskette drive interface cable
New connect it back to the drive you must connect SATA interface cable and SATA power connector or 4-pin Moelx connector.
새로운 당신은 SATA 인터페이스 케이블과 SATA 전원 커넥터, 4 핀 Moelx 커넥터를 연결해야 다시 드라이브에 연결합니다.
All prices on this site are shown in Philippine Pesos. Note: Comes with complete operator's manual and Windows software on CD ROM and 1.8 m (6') USB interface cable.
참고: 운영자 매뉴얼, CD에 담긴 Windows 소프트웨어 및 1.8 m (6') USB 인터페이스 케이블과 함께 제공됩니다.
Connect either end of the interface cable to the drive.
This requires a special interface cable.
While transferring files from computer to the drive if you eject the interface cable then also the data gets corrupt and leaves it inaccessible.
그런 다음 인터페이스 케이블을 꺼낼 경우 드라이브에서 컴퓨터로 파일을 전송하는 동안 또한 데이터가 손상 얻고 액세스를 떠난다.
Disconnect the diskette drive interface cable from the floppy connector on the backplane board.
Attach one end of the interface cable to the connector on the host adapter.
If the problem is resolved, replace the interface cable with a known good cable.
If it does not spin, check that the power connector and the interface cable are securely attached.
드라이브가 회전하지 않으면 전원 커넥터와 인터페이스 케이블이 제대로 연결되었는지 확인합니다.
Disconnect the optical drive interface cable from the optical drive.
옵티컬 드라이브에서 옵티컬 드라이브 인터페이스 케이블을 분리합니다.
the material of the interface cable is mixed with cotton and fiber which can improve its tensile strength, bending strength
인터페이스 케이블의 물자는 그것의 장력 강도를 개량할 수 있는 섬유와 면, 구부리는 힘과 섞입니다