ATAPI チェンジャが適切に動作していることを確認してください。
Verify that the ATAPI changer is functioning correctly.
ATAPI チェンジャからメディアを取り出すには
To eject media from an ATAPI changer
おそらく、基本的に ATAPI 仕様に準拠するドライブであれば動作す るでしょう。
In other words, all the drives that basically adhere to the ATAPI standard are likely to work.
この場合にはサウンドカードから ATAPI ドライブを取り外し,2 番目のインタフェースに接続してください.
Take the ATAPI drive off the sound card and put it on the second interface.
何とも不思議なことに,ATAPI ドライブがうまく動かないという人がたくさんいます.
Strangely enough, lots of people cannot get their ATAPI drives working, probably because there are a number of things that can go wrong.
対応している ATAPI テープドライバは以下の通りです:
ATAPI tape drives supported are
(パラレルポート汎用 ATAPI 装置)
Parallel port generic ATAPI devices
(パラレルポート ATAPI ディスク)
Parallel port ATAPI disks
(パラレルポート ATAPI テープ)
Parallel port ATAPI tapes
あなたのドライブが ATAPI をきちんと実装していることを知っているなら、少しだけ小さなカーネルにするためにオンにすることができます。
If you know your drive implements ATAPI properly, you can turn this on to get a slightly smaller kernel.
説明書に IDE と記載してあるにも関わらず、実際には ATAPI ではなくメーカー独自のインターフェイスを持ったドライブである場合があります。
Some documentation may refer to proprietary interfaces as IDE, leading some to mistakenly believe they are ATAPI drives.
特に、SCSI デバイスと ATAPI デバイスが混在している環境では、ほとんどのものをモジュールとして作成する方がよいでしょう。
Especially in environments where SCSI and ATAPI devices are mixed, you better build most things as modules.
PARIDE のサポートを選択したのなら、ここで Yと答えてパラレルポート ATAPI テープドライバを組み込むか、M と答えてローダブルモジュールを作成します。
If you chose to build PARIDE support into your kernel, you may answer Y here to build in the parallel port ATAPI disk driver, otherwise you should answer M to build it as a loadable module.