Gesproken tekst vertalen, offlinefuncties, synoniemen, vervoegingen, educatieve spelletjes
Publiciteit
Sluit u aan bij Reverso, het is gratis en gemakkelijk!
target microcontroller
Vertaling van "target microcontroller" in Chinees
目标微控制器
At this voltage, microcontrollers have restrictions on speed and functionality, and this should be understood before choosing a target microcontroller for the system.
在该电压下，微控制器对速度和功能有限制，在选择系统的目标微控制器前应该知晓这一情况。
It allows complete control and tracing execution of a users program and access to all registers and memory spaces of the target microcontroller, without consuming any device resources or introducing wait-states or other non-standard behavior.
它允许对用户程序的完全控制和跟踪执行，并可以访问所有寄存器和目标微控制器的内存空间，无需占用任何器件资源或引起等待状态或其他非标准表现。
The PDS900 is a fully featured in circuit emulation and programming system supporting the entire NXP P89LPC900 family of high performance microcontrollers. It allows complete control and tracing of execution of a users program and access to all registers and memory spaces of the target microcontroller, without consuming any device resources or introducing wait-states or other non-standard behavior. It also allows programming of the Flash program memory and configuration options of production microcontroller devices.
PDS900 是一个全功能的在线仿真和编程系统，支持整个 NXP P89LPC900 系列的高性能微控制器。它允许完全控制和跟踪用户程序的执行，并且允许访问目标微控制器的所有寄存器和储存器空间，而不消耗任何设备资源或导致等待状态或其它非标准行为。它还允许对闪存程序存储器进行编程，并对生产微控制器设备设置配置选项。
The E7 is the latest on-chip debug module from Renesas Technology is a low-cost solution for connecting to the Tiny on-chip debug interface of the H8/Tiny, H8/Super Low Power (SLP) and R8C/Tiny series microcontrollers. The emulator enables real-time in-system debugging on the target device, using the dedicated debugging resources built into the target microcontroller in your user hardware. The E7 connects to the host machine using the USB interface and so does not require the user to open the machine casing to install it. The E7 is small and light in weight, it does not use large interface cables and so can easily be used in a normal office environment.
E7 是 Renesas Technology Corporation 提供的最新片上调试模块。它是低成本解决方案，用于连接 H8/微型、H8/超低功率 （SLP） 和 R8C/微型系列微控制器的微型片上调试接口。该仿真器使用用户硬件的目标微控制器中内置专用调试资源在目标设备上进行实时系统内调试。E7 使用 USB 接口连接主机，因此不需要用户打开机箱进行安装。E7 体积小，重量轻，不使用大接口线缆，因此便于办公环境使用。
uVision3 integrated development environment integrating the ARM RealView Compilation Tools and Keil's debugging software so that users can quickly and easily develop and debug their applications while they run on a target microcontroller.
uVision3 集成开发环境整合了 ARM RealView 编译工具和 Keil 调试软件，可以在目标微控制器上运行的同时快速且轻松地开发和调试应用程序。
Supports fast ISP via the JTAG port of the target microcontroller Supports writing/reading of FLASH, EEPROM, FUSE and LOCK bits in both EDS and Autoprogram modes Only supports programming of ONE ATmega device at a time JTAG ISP requires 4 dedicated signals from the programmer to the target ATmega device
通过目标微控制器的 JTAG 端口支持快速 ISP 支持以 EDS 和自动编程模式读/写闪存、EEPROM、？丝和锁位 一次只支持编程一个 ATmega 设备 JTAG ISP 要求从编程器向目标 ATmega 设备提供 4 个专用信号
The ICD 2 module is a low cost development tool which connects between the PC and the designers target board allowing direct in circuit debugging of the PICmicro target microcontroller. Debugs PIC18F2X2, PIC18F4X2, PIC18F2X8, PIC18F4X8, PIC18FXX20 and PIC18CX01 series of Microchip parts. Programs can be executed in real time or single step, watch variables established, breakpoints set, memory read/writes accomplished and more. It can also be used as a development programmer for the microcontrollers. USB (Full Speed 2 Mbits) and RS232 interface to host PC. Totally enclosed. Supports low voltage to 2V (2V ~ 6V range).
ICD 2 模块是一款低成本的开发工具，可在电脑和设计目标板之间建立连接，可直接对 PICmicro 目标微控制器进行在线调试。调试 PIC18F2X2、PIC18F4X2、PIC18F2X8、PIC18F4X8、PIC18FXX20 和 PIC18CX01 系列的 Microchip 零件。可实时或单步执行程序、监视设定的变量、设置断点、实现存储器读/写等。它也可用作微控制器的开发编程器。采用 USB（全速 2 兆位）和 RS232 连接电脑主机。完全封闭。支持低电压，最低 2V（2V ~ 6V 范围）。
They come with all the hardware and software you need to start developing applications for the STR7 ARM7TDMITM and STR9 ARM966ETM core-based microcontrollers. The kits come complete with evaluation board and target microcontroller, the ULinkTM USB-to-JTAG in-circuit debugger/programmer Keil's uVision3 integrated development environment for ARM and the 16KB code-size limited version of the ARM RealView Compilation Tools.
它们具有需要的所有硬件和软件，以开始开发基于 STR7 ARM7TDMITM 和 STR9 ARM966ETM 内核的微控制器的应用程序。该套件提供评估板和目标微控制器、ULinkTM USB 到 JTAG 在线调试器/编程器、Keil 的 uVision3 集成开发环境（用于 ARM 和 RealView 编译工具的 16KB 限制版本）。
Synoniemen voor target microcontroller in het Engels
Woord & uitdrukking van de dag
Afbeelding van de dag
Resultaten: 8. Exact: 8. Verstreken tijd: 12 ms.
