Vertaling van "LED 1" in Duits
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
LED 1 is blinking and the display shows the preset temperature.
Die LED 1 blinkt und auf dem Display wird die eingestellte Temperatur angezeigt.
When the LED 1 is shining, the additional tension is active.
Wenn die LED 1 leuchtet ist die Zusatzspannung aktiviert.
Pure Finnish birch wood: Table lamp LED 1 by Tunto is a design lamp made of birch wood, either pure or outside lacquered.
Echte finnische Birke: Die Tischleuchte LED1 von Tunto ist eine Designerleuchte aus Birkenholz, entweder pur oder an der Außenseite lackiert.
LED 1 on board 2 is being switched off.
LED 1 on board 2 wird ausgeschaltet.
LED 1 on board 2 is being switched on.
LED 1 an Board 2 wird eingeschaltet.
The higher the degree of protection, the more the LED 1 lighted wall light is protected against dust and water.
Je höher der Schutzgrad, desto mehr ist die LED 1 Lichtwandleuchte gegen Staub und Wasser geschützt.
21 LED 1 lights green - a connection exists (e.g. to a hub).
21 LED 1 leuchtet grün - es besteht eine Verbindung (z. B. zu einem Hub).
Mode 03 now shows that LED 1 and 2 in the range of 0 - 2ms are not full lit.
Mode 03 zeigt nun dass LED 1 und 2 im Bereich von 0 - 2ms nicht voll leuchten.
The status indicators (LED 1+2) for the opened or closed circuit output is only is only selectable externally by an PLC or similar.
Die Schaltzustandsanzeige (LED 1) für den geschlossenen Schaltausgang wird extern durch eine SPS-Steuerung o.ä. geschaltet.
Lamp - solar, LED 1, 6-8 hours of sunshine hours, stainless steel/ plastic, 8.6x50cm, AAA battery pack...
Lampe Solar-, LED 1, 6-8 Stunden Sonnenstunden, Edelstahl/ Kunststoff, 8.6x50cm, AAA-Batterie-Pack... -20
With the new EPROM only LED 1 will show level in the above setup. 5.
Mit dem neuen EPROM wird im obigen Setup nur die Level LED 1 ein Signal anzeigen.
9 EN WARNING: - When the device is switched on, it starts recording automatically and LED 1 flashes blue.
21 DE WARNUNG: - Wenn das Gerät eingeschaltet ist, beginnt es automatisch mit der Aufzeichnung und die LED 1 blinkt blau.
The modem is ready for operation when LED 1 flashes continuously in 250-ms cycles). 6 Installation Guide
Das Modem ist betriebsbereit, wenn LED 1 dauerhaft blinkt (250 ms an/ 250 ms aus).