Vertaling van "RL02 disk" in Duits
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
This looks as follows at the RL02 disk drive
Bei dem RL02 Laufwerk sieht das dann wie folgt aus
The transfer rate at the RL02 disk drives is based on 4.1 magabits/sec and therefore very difficultly to clone it with the 50 MHz FPGA Clock.
Die Übertragungsrate bei den RL02 Laufwerken liegt bei 4.1 magabits/sec und ist mit der 50MHz FPGA Clock somit schwer nachzubilden.
RL02 disk drives: Service and Maintenance from Joerg.
Service und Fehlerbehebung der RL02 Laufwerke von Joerg.
Ready for use MFM DECODER with CLOCK and DATA RECOVERY for DEC RL02 disk drives based on SHIFT REGISTER technology with Clock-Sync.
Fertiger MFM DECODER mit CLOCK and DATA RECOVERY(CDR)für DEC RL02 Laufwerke basierend auf Shift-Register mit Clock-Sync.
The RL02 disk drive was screwed for place reasons to the wall.
Das RL02 Laufwerk wurde aus Platzgründen buchstäblich an die Wand geschraubt.
Under the RL02 disk drive the Scope and my PDP-11/23 SE (chapter 5) can be recognized.
Darunter ist das Scope und meine PDP-11/23SE (Kapitel 5) zu erkennen.
The project started at the end of 2012, parallel to the RL01/ Rl02 Disk Emulator.
However the Software is directly dependent on the condition of the disk drive, in my case a DEC RL02 disk drive.
Die Software ist allerdings direkt abhängig von dem einwandfreien Zustand des Storage Laufwerks, in diesem Fall eine DEC RL02.
In the first step I therefore developed a circuit diagram to read the command register of the RL02 disk drive.
At the example of the RL02 disk drive running with a 4.1Mhz clock will result in 3 different timing periods which than can be dissolved as follows are the results
Am Beispiel des RL02 Laufwerks mit einer 4.1 Mhz Clock ergeben sich folgende 3 unterschiedliche Perioden, welche dann wie folgt aufgelöst werden können
First, a possibility had to be found to measure the differential RL02-bus signals and convert it to TTL level for further processing. For this purpose I designed a special, 40-pole ribbon cable for the connection between RLV-12 controller and the RL02 disk drive.
Zuerst musste ich ein spezielles, 40 poliges Flachbandkabel anfertigen für die Verbindung zwischen RLV-12 Controller und dem RL02 Laufwerk mit einen zusätzlichen Connector für die Hardware des RL02 Simulator um sich quasi in den RL02-Bus einzuhängen.