Vertaling van "a BL-Ctrl" in Duits
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
If on a BL-Ctrl the red LED is blinking or there is no LED ON an error occurred.
Sollte auf einem BL-Ctrl die rote LED blinken oder keine LED an sein, liegt ein Fehler vor.
If you get an I2C Error displayed in the virtual display mostly you have soldering defects/short circuits at the I2C Bus (C/D) or a defect on a BL-Ctrl.
Wird im virtuellen Display ein I2C Error angezeigt, liegt in den meisten Fällen entweder ein Lötfehler/Kurzschluss am I2C Bus (C/D) vor, oder ein defekt an einem BL-Ctrl.
If on a BL-Ctrl the red LED is flashing, or both LED's are OFF or only on one BL-Ctrl the green and red LED is ON then you can determine a failure.
Sollte auf einem BL-Ctrl die rote LED blinken, beide LED aus sein oder nur bei einem BL-Ctrl die grüne und rote LED gleichzeitig an sein, liegt ein Fehler vor.
Has a BL-Ctrl now a soldering defect, a short circuit or is defect by itself this effects the whole I2C Bus (distributor).
Hat also ein BL-Ctrl einen Lötfehler, einen Kurzschluss oder ist defekt, wirkt dies sich auf den ganzen I2C Bus (Verteiler) aus.
If you get, after re-soldering a BL-Ctrl, again an I2C Error the last connected BL-Ctrl will be defective.
Wird allerdings nach dem erneuten Einlöten eines BL-Ctrl (I2C) wieder ein "I2C Error" angezeigt, wird der zuletzt angeschlossene BL-Ctrl defekt sein.
With a BL-Ctrl V1.2 the motor adresses can be set by a jumper (soldered) directly on the board. Addresses 1-4
Bei der BL-Ctrl V2.0 wird die jeweilige Motoradresse von 1-8 per Lötjumper (aus Lötzinn) auf der Platine eingestellt.