We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
beim Arduino
am Arduino messen
Field-effect transistor In order to control currents above 2mA at the Raspberry Pi respectively 40mA at the Arduino, an amplifying circuit is needed, what field-effect transistors are good for.
Sollen Ströme oberhalb von 2mA beim Raspberry Pi beziehungsweise 40mA beim Arduino geschaltet werden, so muss das Signal der GPIOs verstärkt werden, wozu sich am einfachsten Feldeffekttransistoren eignen.
Caused by this low current, the series resistor at the Arduino must be at least 5V/ 2mA = 2.5kΩ or else the LED will get damaged when connected to 5V!
Damit muss natürlich ein größerer Vorwiderstand von mindestens 5V/ 2mA = 2.5kΩ beim Arduino verwendet werden, da die LED ansonsten zerstört wird!
If the GPIO is turned "on", (almost) 3.3V at the Raspberry and 5V at the Arduino are attached to the gate pin of the transistor.
Liegen 3.3V beim Raspberry beziehungsweise 5V beim Arduino am eingeschalteten GPIO, so wird der Transistor eingeschaltet.
The second terminal of R1 is connected to +3.3V at the Raspberry respectively +5V at the Arduino.
Das zweite Ende von R1 wird mit +3.3V beim Raspberry und mit +5V beim Arduino verbunden.
Limit the current per GPIO to 10mA at the Arduino and 3mA at the Raspberry Pi to stay on the safe side!
Beim Arduino sollte der Strom pro GPIO auf 10mA, beim Raspberry Pi auf 3mA beschränkt werden!
Use the 3.3V pin at the Raspberry and the 5V pin at the Arduino!
Verwendet den 3.3V Pluspol beim Raspberry Pi und den 5V Pluspol beim Arduino!
If the GPIO is turned "on", the potential is 3.3V at the Raspberry Pi and 5V at the Arduino Uno.
Wird der Pin per Software eingeschaltet, so liegt zwischen Pin und Minuspol eine Spannung von 5V beim Arduino beziehungsweise 3.3V beim Raspberry Pi an.
At the Arduino, the TX line goes to pin 8 and the RX line goes to pin 9.
Die TX-Leitung geht beim Arduino auf Pin 8 und die RX-Leitung geht auf Pin 9.
Record the voltages between ground (minus) and the sensor pins at the Arduino board again.
Erneut die Spannungen zwischen Masse (Minus) und den Sensor-Pins am Arduino messen.
In this article we take a quick look at the Arduino's evolution so far and review some of the most recent additions to the Arduino ecosystem of open source hardware.
In diesem Artikel werfen wir einen Blick auf die bisherige Entwicklung von Arduino und sehen uns einige der neuesten Ergänzungen des Ökosystems der Open-Source-Hardware von Arduino an.
After studying the datasheet and some other resources (1, 2, 3 - sorry, all in German) on similar projects I was able to control the switches using only one I/O pin at the Arduino.
Nach intensivem Studium des Datenblatts und verschiedenen anderen Quellen (1) (2) (3) mit ähnlichen Projekten habe ich es auch tatsächlich auch wie folgt geschafft, die Steckdose mit einem einzigen Datenkabel am Arduino zu steuern.
Use a multimeter to record the voltages between gound (minus) and the sensor pins (10, 11, 12, 13, A2, A3, A4, A5) at the Arduino board.
Nun mit einem Multimeter die Spannungen zwischen Masse (Minus) und den Sensor-Pins (10, 11, 12, 13, A2, A3, A4, A5) am Arduino messen.
So it is time to search for something bigger. You should look at the Arduino Mega 2560, which almost brings much more program memory, tons of new ports, more variable memory and additional static EEPROM memory with it.
Also wird es Zeit sich nach etwas größerem umzusehen, um nun nicht auf ein anderes System umzusteigen, sollte man sich den Arduino Mega 2560 anschauen, welcher den Programmspeicher fast verachtfacht, massenweise neue Ports, mehr Variablenspeicher und zusätzlichen statischen EEPROM-Speicher mitbringt.
Potentieel gevoelige of ongepaste informatie
Er worden alleen voorbeelden gegeven om u te helpen het woord of de woordcombinatie waarop u hebt gezocht, te vertalen. Deze worden niet door ons geselecteerd of gevalideerd en kunnen ongepaste taal bevatten. Wij vragen u melding te maken van voorbeelden die dienen te worden aangepast of verwijderd. Vertalingen met grof of informeel taalgebruik worden meestal rood of oranje gemarkeerd.