Vertaling van "20dB" in Japans
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
Attenuation as much as 20dB obviously has a bad influence to the sound quality.
アッテネーターで20dBも落としたら、明らかに音質に悪影響を及ぼします。
On-chip power detector gives a 20dB dynamic range.
オンチップのパワーディテクタは、20dBのダイナミックレンジを実現しています。
Therefore, the 20dB bandwidth should be ±7 times half the data rate.
したがって、20dBの帯域幅はデータレートの半分の±7倍になるはずです。
Decoding the data from this transmitter presents an interesting challenge because the modulation is about 20dB *below* the carrier.
この送信機からのデータをデコードするのはなかなか 興味深い挑戦となります。 これは変調がキャリアより約 20dB 下 のレベルにあるためです。
However, it is also reported that the difference of the measurement value of maximum 20dB is caused by the difference of the wiring of the power cable.
しかし、それでも、電源ケーブルの引き回しの違いにより、最大20dBの測定結果の違いも報告されています。
A low noise brake has been incorporated as a standard feature, and its brake operating sounds have been reduced by a maximum of 20dB (compared with our products).
低騒音ブレーキを標準採用し、ブレーキ動作音を最大で20dB(当社比)低減しました。
The 20dB load/pad is compensated for by calibration of the network analyzer to include its effect.
ネットワークアナライザのキャリブレーションによって20dB負荷/パッドを補償し、この影響に対処します。
This lesser-known specification says that the measurement bandwidth must be at least 1% of the allowable 20dB emission bandwidth.
このあまり知られていない仕様では、測定帯域幅は許容される20dBの放射帯域幅の少なくとも1%でなければならないと定めています。
[Note] The lateral sensitivity of the accelerometer is -20dB or less, so measurement axis difference around ±10 degrees between the X, Y axis and actual measurement axis (direction) does not affect to the measurement value.
【メモ】 振動ピックアップの横感度は -20dB 以下であるため、感度軸と実際の測定軸が ±10 程度のずれは測定値には殆ど影響しません。
In a realistic setting, a good guideline is to subtract 20dB from the "empty parking lot" loss in Equation 1 to allow for the instantaneous fading that comes from multiple surfaces.
現実的な設定では、複数の表面によって生じる瞬間フェージングに対応するため、式1の空いている駐車場の損失から20dB差し引くことが、手引きとして推奨されているからです。
With this test load, the return loss should be 20dB higher than the requirements shown in Table 1.
このテスト負荷を用いた場合、リターンロスは表1に示す要件より20dB大きくなければなりません。
With this test load the return loss should be 20dB higher than the requirements shown in Table 1.
このテスト負荷を接続した状態で、リターンロスは表1に示した要件よりも20dB高くなるはずです。
DFEs can typically handle 20dB of channel loss at a frequency half the bit rate, assuming the channel is not degraded by reflections and crosstalk.
チャネルが反射やクロストークによって劣化しないと仮定した場合、DFEは通常、ビットレートの半分の周波数で20dBのチャネル損失を処理します。