Download for Windows Premium
Publiciteit
second reference voltage

Vertaling van "second reference voltage" in Japans

We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
第2の基準電圧
第2基準電圧
The second reference voltage is a voltage obtained by adding or subtracting a minimum resolution voltage to or from the first reference voltage.
第2の基準電圧は第1の基準電圧に対して、最小分解能の電圧を加算または減算した電圧である。
When the drain voltage is below the second reference voltage, the gate voltage control part (6) so controls the gate voltage as to be proportional to the drain voltage.
又、ドレイン電圧が第1の基準電圧より高い電圧である第2の基準電圧以上の時は、初期設定したゲート電圧を保持し、ドレイン電圧が第2の基準電圧以下のときにはゲート電圧をドレイン電圧と比例させて制御する。
The reference voltage is set to the first reference voltage, but is set to the second reference voltage when the detected gas is atmospheric air.
基準電圧は、第1基準電圧に設定される一方、被検出ガスが大気であるときは第2基準電圧に設定される。
There is provided a semiconductor device including; a pump circuit (10) for boosting an output node connected to a memory cell array; an oscillator (12) for outputting clock to the pump circuit; and a detection circuit (16) for operating the oscillator if the voltage of an output node (17) of the pump circuit is lower than a first reference voltage and stopping the oscillator if the voltage of the output node is higher than a second reference voltage.
本発明は、メモリセルアレイに接続された出力ノードを昇圧するポンプ回路(10)と、ポンプ回路にクロックを出力する発振器(12)と、ポンプ回路の出力ノード(17)の電圧が第1の参照電圧より低い場合、発振器を動作させ、出力ノードの電圧が第2の参照電圧より高い場合、発振器を停止させる動作信号を発振器に出力する検出回路(16)と、を具備する半導体装置およびその制御方法である。
A data receiver comprises an amplifying circuit (41) that amplifies a received duo-binary data with a predetermined gain for output; an offset canceling part (56,57) that cancels the offset of an output signal of the amplifying circuit (41); and a data determining part (43,44) that samples, based on a first reference voltage and a second reference voltage lower in level than the first reference voltage, the output signal of the amplifying circuit (41), thereby determining which one of the three values constituting the duo-binary data the received duo-binary data exhibits.
解決手段 本発明に係る光学手段駆動装置は、光源から出力される光束を光ディスクに集光する複数の光学手段、フォーカシングコイル、及びトラッキングコイルを保持するホルダと、光ディスクの略半径方向、及び光ディスクに対して略垂直な方向にホルダを移動可能に支持する複数の弾性支持部材と、ホルダの内部に配置されるインナーヨーク、フォーカシングコイルおよびトラッキングコイルに対して磁界を発生させるマグネットを保持するベースとを備える光学手段駆動装置において、ホルダにおけるインナーヨークの上面を閉構造としたものである。
The reference voltage generation circuit increases the potential difference between the first reference voltage and the second reference voltage when the adjusted current increases and reduces the potential difference when the adjusted current is reduced.
基準電圧発生回路は、調整電流が増加する場合に第1の基準電圧と第2の基準電圧との電位差を大きくし、調整電流が減少する場合には該電位差を小さくする。
The first and second temperature detection elements are arranged to receive different amounts of heat, and the signal for controlling the temperature of the heater is arranged to become the logical OR of a signal obtained by comparing the temperature signal voltage of the first temperature detection element with a first reference voltage and a signal obtained by comparing the temperature signal voltage of the second temperature detection element with a second reference voltage.
立ち上り時の即暖性に優れるとともに、その後には温度の安定性を満たし快適性を向上することが可能な採暖器具と車両座席用採暖装置を提供することを目的とし、そのため、ヒータ素子を有する採暖物と、前記採暖物の温度を検知する第一の温度検知素子と、前記採暖物の温度を検知する第二の温度検知素子と、前記第一の温度検知素子及び前記第二の温度検知素子から出力される信号により前記採暖物の温度を制御する温度制御回路と、を具備し、前記第一の温度検知素子と前記第二の温度検知素子は夫々が受ける熱量が異なるような位置に配置されているとともに、前記採暖物の温度を制御する信号は、前記第一の温度検知素子の温度信号電圧と第一の基準電圧とを比較してなる信号と、前記第二の温度検知素子の温度信号電圧と第二の基準電圧とを比較してなる信号と、の論理和となるように構成されている。
An A/D conversion unit performs an A/D conversion operation twice during the hold period of the analog value, in the first conversion operation, compares the analog value with a first reference voltage and outputs the result of the comparison as first conversion data, and in the second conversion operation, compares the analog value with a second reference voltage and outputs the result of the comparison as second conversion data.
A/D変換部はアナログ値のホールド期間中に、2度A/D変換動作を行い、第1回目の変換動作では、前記アナログ値を第1の基準電圧と比較して比較結果を第1の変換データとして出力し、第2回目の変換動作では、前記アナログ値を第2の基準電圧と比較して比較結果を第2の変換データとして出力する。
The successive approximation type A/D converter circuit further comprises a selecting means (SEL1) that selects one of a first group of voltages and supplies, to the local D/A converter circuit, the selected voltage as a first reference voltage that provides the upper limit value of a range of A/D convertible voltages; a selecting means (SEL2) that selects one of a second group of voltages having lower values and supplies, to the local D/A converter circuit, the selected voltage as a second reference voltage that provides the lower limit value of the range of A/D convertible voltages; and a register (REG1) that establishes a value that decides the selection states in the first and second selecting means.
入力アナログ電圧と比較電圧の大小を判定する比較回路CMPと、該比較回路の判定結果を順次取り込むレジスタSARと、該レジスタの値を電圧に変換し前記比較電圧とするローカルDA変換回路とを備えた逐次比較型AD変換回路において、第1の電圧群の中から一つを選択してA/D変換可能な電圧範囲の上限値を与える第1基準電圧としてローカルDA変換回路へ供給する選択手段SEL1と、電圧値の低い第2の電圧群の中から一つを選択して電圧範囲の下限値を与える第2基準電圧として供給する選択手段SEL2と、第1選択手段と第2選択手段における選択状態を決定する値を設定するレジスタREG1とを設けて、課題を解決した。
The humidity of the detected gas is detected on the basis of the error, ΔIp, between the Ip electric current detected in a state controlled by the first reference voltage and the Ip electric current detected in a state controlled by the second reference voltage.
被検出ガスの湿度が、第1基準電圧に制御された状態で検出されたIp電流と、第2基準電圧に制御された状態で検出されたIp電流との誤差ΔIpに基づいて検出される。
A D/A converter comprising an R-2R ladder resistor network (11) where a resistor R and a resistor 2R consisting of a series connection of the resistors R are connected in ladder, drive/latch circuits BL0-BL2 delivering a drive signal based on digital input signals D0-D2 latched by a clock signal, and select circuits S0-S1 for selecting any one of a first reference voltage VH and a second reference voltage VL being applied to the voltage input terminal of the R-2R ladder resistor network (11) corresponding to each bit of the digital input signals D0-D2.
抵抗Rを直列に接続した抵抗2Rと抵抗Rとをラダー状に接続したR-2Rラダー抵抗網11と、クロック信号によりラッチされたデジタル入力信号D0~D2に基づいて駆動信号を出力する駆動/ラッチ回路BL0~BL2と、その駆動/ラッチ回路BL0~BL2からの駆動信号によって、デジタル入力信号D0~D2の各ビットに対応するR-2Rラダー抵抗網11の電圧入力端子に、第1の基準電圧VHまたは第2の基準電圧VLのいずれを印加するかを選択する選択回路S0~S1とを備える。
In the disclosed source follower amplifier which comprises means for maintaining the space between a substrate node and an output node of an input MOSFET at a constant non-zero voltage regardless of the input potential, the disclosed source follower amplifier is provided with the means, which are a first switch element disposed between a first reference voltage source and the output node of the input MOSFET, a second switch element disposed between a second reference voltage source and the substrate node of the input MOSFET, and a capacitance element disposed between the substrate node and the output node of the input MOSFET; wherein the first and second switch elements are short-circuited during the calibration time in the operating time of the input MOSFET, and the first and second switch elements are opened during the usage time thereof.
入力MOSFETの基板ノードと出力ノードとの間を、入力電位に関わらず、非零の一定電圧に保つ手段を有するソースフォロア増幅器において、上記手段は、入力MOSFETの出力ノードと第1の参照電圧源との間に設けられた第1のスイッチ素子と、該入力MOSFETの基板ノードと第2の参照電圧源との間に設けられた第2のスイッチ素子と、該入力MOSFETの基板ノードと出力ノードとの間に設けられた容量素子であって、入力MOSFETの動作時間の内の、校正時間には該第1及び第2のスイッチ素子を短絡し、使用時間には該第1及び第2のスイッチ素子を開放することを特徴とするソースフォロア増幅器。
An oscillation circuit includes: a triangular wave generation circuit for generating a triangular wave signal according to an output clock signal; a comparison circuit for generating a clock signal in accordance with a comparison between the triangular wave signal and a first reference voltage and a second reference voltage; a current adjusting circuit for adjusting the adjusted current value in accordance with the power supply voltage for the comparison circuit; and a reference voltage generation circuit for generating the first reference voltage and the second reference voltage having a voltage difference in accordance with the adjusted current value.
この発振回路は、出力クロック信号に応じて三角波信号を発生する三角波発生回路と、三角波信号と第1の基準電圧および第2の基準電圧との比較に応じてクロック信号を生成する比較回路と、比較回路のための電源電圧に応じて調整電流の値を調整する電流調整回路と、調整電流の値に応じた電圧差を有する第1の基準電圧および第2の基準電圧を生成する基準電圧発生回路とを備える。
Er zijn geen resultaten gevonden voor deze term.
Ga naar Premium voor toegang tot miljoenen vertaalvoorbeelden, onbeperkt woorden opslaan en leren, zonder advertenties.

Synoniemen voor second reference voltage in het Engels

Woord & uitdrukking van de dag
Afbeelding van de dag
braid: weave of three or more strands
Ontdek het woord
Publiciteit

Resultaten: 19. Exact: 19. Verstreken tijd: 30 ms.