Vertaling van "ac systems" in Pools
A check for the AC systems is not necessary because of the lower current at standstill.
Geometry of overhead contact line for AC systems
For AC systems, the use of other material than those specified above is an open point.
W przypadku systemów AC stosowanie innego materiału niż opisany wyżej to punkt otwarty.
harmonics and dynamic effects for AC systems (4.2.9), and
Zakłócenia harmoniczne i dynamiczne systemów AC (4.2.9) oraz
This product is for sealing and gluing in locations exposed to permanent high temperatures of up to +250ºC such as furnaces, stacks, heating devices, ventilation systems, AC systems, flues and smoke exhaust ducts.
Zastosowanie Wyrób przeznaczony jest do uszczelniania i klejenia miejsc narażonych na stałe działanie wysokich temperatur do +250 oC takich jak: paleniska, kominy, urządzenia grzewcze, instalacje wentylacyjne, klimatyzacyjne, spalinowe, kanały dymowe.
This product is for sealing and gluing in locations exposed to permanent high temperatures up to +250ºC (periodically up to +350ºC) such as: furnaces, stacks, heating devices, ventilation systems, AC systems, flues and smoke exhaust ducts.
Wyrób przeznaczony jest do uszczelniania i klejenia miejsc narażonych na stałe działanie wysokich temperatur do +250oC (okresowo do +350oC) takich jak: paleniska, kominy, urządzenia grzewcze, instalacje wentylacyjne, klimatyzacyjne, spalinowe, kanały dymowe.
Geometry of overhead contact lines for AC systems
Harmonics and dynamic effects for AC systems - 4.2.9
Zakłócenia harmoniczne i dynamiczne systemów AC - 4.2.9
Hypothesis and data considered for the compatibility study for AC systems, as required in clause 4.2.8.2.7.
Hipoteza i dane brane pod uwagę do celów badania zgodności systemów AC, zgodnie z wymogami pkt 4.2.8.2.7.
System energy disturbances for AC systems
Zakłócenia w systemach energetycznych w przypadku systemów AC
Harmonics and dynamic effects for AC systems
Zakłócenia harmoniczne i dynamiczne systemów AC
The mean contact force Fm formed by the static and aerodynamic components of the contact force with dynamic correction which shall be applied on the contact wire is shown in figure 5.1 for AC systems as a function of running speed.
Na rys. 5.1 przedstawiono w funkcji prędkości jazdy średnią siłę stykową Fm będącą wypadkową składowej statycznej i aerodynamicznej nacisku z uwzględnieniem korekcji dynamicznej, jaką należy przykładać do przewodu jezdnego w sieciach prądu przemiennego.
Target for mean contact force Fm for AC systems depending on running speed
Docelowa zależność średniej siły stykowej Fm od prędkości jazdy w sieciach prądu przemiennego