Vertaling van "ms per" in Pools
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
Inference time varies depending on the tool and hardware between 5 and 100 ms per image.
Czas wykonania waha się w zależności od projektu od 5 do 100 ms na obraz.
1785-V80B has program scan time of either 0.5 ms per 1000 words with bit logic, or 2 ms per 1000 words which is typical.
1785-V80B ma czas skanowania programu wynoszący 0,5 ms na 1000 słów z logiką bitową lub 2 ms na 1000 słów, co jest typowe.
Compared to the original implementation, which this time took 1.1 ms per batch, it's 30% faster.
Porównując to do oryginalnej implementacji, która tym razem zajęła 1.1ms na partię, to o 30% szybciej.
As you can see, the best result is from HFD5 - 0.84 ms per batch.
Jak widzicie, najlepszy wynik osiągnął HFD5 - 0.84ms na partię.
The Turbulence Slope calculations are based on the averaged tachogram and expressed in ms per RR interval.
Obliczenia Turbulence Slope opierają się na tachogramie uśrednionym z wszystkich fragmentów rytmu zatokowego po skurczu komorowym i wyrażone w ms/odstęp RR.
For mechanical disk-based systems, where each disk seek will take around 10ms. Sequentially writing data to that same disk takes about 30 ms per MB. So if you sequentially write 100 MB of data to a disk, it will take around 3 seconds.
Przykład W przypadku systemów wykorzystujących dyski mechaniczne, w których każde wyszukiwanie danych na dysku trwa około 10 ms, zapis sekwencyjny na tym samym dysku trwa około 30 ms/MB. W związku z tym zapis sekwencyjny 100 MB danych trwa około 3 sekund.
That's why, in the results above, built-in concurrent loader with built-in dataset took 17ms per batch to load, whereas, as mentioned in "Starting the research" section, in the training itself it took only 1.02 ms per batch.
To dlatego w wynikach powyżej, wbudowany współbieżny loader z wbudowanym datasetem potrzebował 17ms, aby załadować partię, podczas gdy, jak wspomniałem w sekcji "Rozpoczynając research", podczas uczenia zajmowało to tylko 1,02ms na partię.