Vertaling van "netsh" in Pools
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
It is one of the interface name shown by "netsh wlan show interface" command.
Jest to jedna z nazw interfejsów wyświetlana poleceniem "netsh lan show interface".
Changes to the 'netsh interface ipv6' context.
Zmiany w kontekście 'netsh interface'.
Type add address/? at the netsh interface ipv6 command prompt to view the additional parameters.
Aby wyświetlić dodatkowe parametry, wpisz polecenie add address/? w wierszu polecenia netsh interface ipv6.
Entering the netsh wlan context
Przechodzenie do kontekstu netsh wlan
Remarks: List peer names registered by this instance of netsh.
Uwagi: wyświetla nazwy elementów równorzędnych zarejestrowane przez to wystąpienie netsh.
Note To check whether the authentication fails, run the netsh lan show interface command. Cause
Uwaga Aby sprawdzić, czy uwierzytelnianie nie powiedzie się, uruchom polecenie netsh lan show interface.
The example command,?, displays the entire list of commands or parameters supported by netsh.
Opis: Przykładowe polecenie? wyświetla całą listę poleceń lub parametrów obsługiwanych przez netsh.
After that it executes "netsh interface tcp set global autotuninglevel=disabled" command that disables the auto tuning of the Windows PC.
Po to, że wykonuje "netsh interface tcp set globalne autotuninglevel = disabled" polecenie, które wyłącza automatyczne dostrajanie z komputera z systemem Windows.
You can run these commands directly from the Windows Vista command prompt by typing netsh wlan followed by the command, or by switching to the wlan context by using the following instructions.
Polecenia te można uruchomić bezpośrednio z wiersza poleceń w systemie Windows Vista, wpisując netsh wlan, a następnie nazwę polecenia, bądź przechodząc do kontekstu wlan zgodnie z poniższą instrukcją.
To learn index values, use the 'show interface' command at the 'netsh interface ip' Netshell command sub-context.
Aby poznać wartości indeksu, należy użyć polecenia 'show interface' w kontekście polecenia usługi Netshell 'netsh interface ip'.
On XP or below: On Windows 7 and earlier, netsh is bitness specific, so you may want to run the above command twice: This blog has more information.
Na XP lub poniżej: W systemie Windows 7 i wcześniej, netsh jest bitness specyficzny, więc może chcesz uruchomić powyższą komendę dwukrotnie: Ten blog ma więcej informacji.
Type netsh int ip reset and press Enter.
Wpisz netsh int ip reset i naciśnij klawisz Enter.
Type netsh winsock reset and press Enter.
Wpisz netsh winsock reset i naciśnij Enter.