We needed to find the point of intersection to solve the geometry problem.
It was easy to see the point of intersection on the plotted chart.
They used a compass to identify the point of intersection precisely.
Użyli cyrkla, aby dokładnie wyznaczyć punkt przecięcia.
The mathematician explained how to locate the point of intersection effectively.
Matematyk wyjaśnił, jak skutecznie zlokalizować punkt przecięcia.
Therefore, the point of intersection must be outside those ordinary paths.
Dlatego właśnie, punkt przecięcia się tych ścieżek musi być ponad te codzienne drogi.
The point of intersection of the two lines was marked on the graph.
Punkt przecięcia dwóch prostych został zaznaczony na wykresie.
The point of intersection helps determine the solution to the equations.
Punkt przecięcia pomaga określić rozwiązanie układu równań.
So if I extend the incident lines, the point of intersection is here.
Więc jeśli przedłużymy linie w tym przypadku, to punkt przecięcia wypada tutaj.
At each point of intersection... each encounter... suggests a new potential direction.
Każdy punkt przecięcia, każde spotkanie, wskazuje nowy kierunek.
The point of intersection of axial and diagonal lines should get one, it means that we did everything right.
Punkt przecięcia osiowe i ukośne linie powinny dostać jeden, to znaczy, że zrobiliśmy wszystko dobrze.
And if this woman learns that and follows you to your impending point of intersection, well, then that's the end of all of it, honey.
Jeśli ta kobieta się o tym dowie i natrafi na wasz punkt przecięcia, wtedy to się wszystko skończy, kochana.
The antenna and the point of intersection of the side of the engine nearest to the antenna with the major axis must each be located at a focal point of the ellipse.
Antena i punkt przecięcia najbardziej zbliżonego do anteny boku silnika z osią główną muszą znajdować się każde w punkcie ogniskowym elipsy.
the point of intersection H of the lines hh and vv shall be situated within the isolux corresponding to 90 % of maximum illumination.
punkt przecięcia H linii hh i vv powinien mieścić się w izoluksie odpowiadającej 90% maksymalnego natężenia oświetlenia.