The Oxygen Sensor monitors how much oxygen is in the vehicle's exhaust.
1 most common fix is "replace Oxygen Sensor."
Among the different ways to control vehicle emissions we will focus on the lambda Exhaust Gas Oxygen Sensor.
Entre las diferentes maneras de controlar las emisiones de los vehículos nos centraremos en la sonda lambda.
This oxygen sensor is comprised of a zirconium-dioxide-based solid electrolyte.
Esta sonda lambda consta de un electrolito sólido de dióxido de circonio.
Use "UP" "DOWN" and "CONFIRM" choose "Voltage signal" and "Oxygen Sensor Signal".
Utilice "ENCIMA" de "ABAJO" y "CONFIRME" eligen la "señal del voltaje" y "la señal del sensor del oxígeno".
Oxygen Sensor damaged by excess lead in the emission gases.
Sonda Lambda dañada por un exceso de plomo en las emisiones de gases.
Remember that anytime you encounter one of these situations you should replace the Oxygen Sensor.
Recuerde que, siempre que se encuentre con cualquiera de estas situaciones, debe reemplazar la Sonda Lambda.
Before installing the Oxygen Sensor, make sure that you are using the appropriate reference for your vehicle.
Antes de instalar la Sonda Lambda, asegúrese de que está utilizando la referencia apropiada para su vehículo.
Through the Oxygen Sensor signal, the control unit recognizes the mixture composition.
Mediante la señal de la Sonda Lambda la unidad de control reconoce la composición de la mezcla.
Check the correct Oxygen Sensor performance at least every 30.000km.
Revise el correcto funcionamiento de la Sonda Lambda al menos cada 30.000km.
Also verify if the body of the Oxygen Sensor shows any dents or signs of being hit that could have caused damage.
Compruebe también si el cuerpo de la Sonda Lambda muestra alguna abolladura o señal de algún golpe que pudieran haberla deteriorado.
To verify the Oxygen Sensor is working properly, without removing it from the vehicle, you will need an oscilloscope.
Para verificar el correcto funcionamiento de una Sonda Lambda, sin desmontarla de nuestro vehículo, necesitamos disponer de un osciloscopio.
Place the Oxygen Sensor in its location, being aware that the wires are not twisted, doubled or caught.
Sitúe en primer lugar la Sonda Lambda en su emplazamiento, asegurándose de que el cable no queda torcido, doblado o atrapado.