Energy saving thanks to the possibility to limit temperature setpoint
Temperature setpoint for current period should display in the top right corner.
Emission levels can be reduced by lowering the condensation temperature setpoint.
Easier control of the temperature setpoint through load swings
Minimum and maximum limitation of room temperature setpoint
In the subsequent commissioning stage, all the operator needs to do is establish the temperature setpoint.
The microprocessor based control system can accept remote signals to start and stop the chiller and to adjust the chilled liquid leaving temperature setpoint and remotely unload each system.
El sistema de control por microprocesador puede aceptar señales remotas para arrancar y parar la planta enfriadora, ajustar el punto de consigna de la temperatura de salida del agua fría y reducir la capacidad de cada circuito a distancia.
In addition, a temperature control thermostat can be installed to include an additional heating control in order to maintain the desired temperature setpoint of the medium.
Asimismo, se puede instalar un termostato de control de temperatura para incluir un control adicional y mantener así el punto de ajuste de la temperatura deseada del producto.
Chilled water temperature setpoint is always calculated in real time, as the rack load changes over time. close
El punto de trabajo del agua fría se calcula en tiempo real, según las variaciones de la carga emitidas por el rack.
This allows you to see the alarm values along with the actual parameter value, and in the case of a temperature control zone, the temperature setpoint.
Esto le permite ver los valores de alarma junto con el valor real del parámetro, y en el caso de una zona de control de temperatura, el punto fijo de temperatura.
Once the retort is cooled to the programmed temperature setpoint, the cold water inlet valve on the heat exchanger closes and the pressure inside the retort is automatically relieved.
Una vez el retorta es enfriado a la temperatura de ajuste programada, la válvula de entrada de agua fría en el intercambiador de calor cierra y la presión adentro del retorta es automáticamente aliviado.
Emission levels can be reduced by lowering the condensation temperature setpoint.
The wall temperature setpoint should be held at a constant nominal operating temperature, within this range, to a tolerance of ± 10 ºC and not exceed the wall temperature of the ET (paragraph 1.4.4.2).
El punto de referencia de la temperatura de pared deberá mantenerse a una temperatura de funcionamiento nominal constante, dentro de ese intervalo, con una tolerancia de ± 10 ºC, y no superar la temperatura de pared del tubo de evaporación (punto 1.4.4.2).