Vertaling van "SCSI IDs" in Duits
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
Check the SCSI IDs of the connected units.
Überprüfen Sie die SCSI-IDs der angeschlossenen Geräte.
All the devices connected to the controller and their SCSI IDs are listed.
Alle Geräte, die mit dem Controller verbunden sind, und ihre SCSI-IDs werden aufgeführt.
If you use SCSI and if your connections are set, turn off the SCSI devices and check the SCSI IDs of the devices.
Wenn Sie SCSI verwenden und die Verbindungen festgelegt sind, schalten Sie die SCSI-Geräte aus, und überprüfen Sie die SCSI-ID der Geräte.
If multiple SCSI units shall be connected to the CYBERSTORM PPC SCSI, the SCSI IDs of all these units have to be adjusted so that no unit has the same ID.
Sollen mehrere SCSI-Geräte am CYBERSTORM PPC SCSI angeschlossen werden, so müssen bei diesen Geräten die SCSI-ID so eingestellt werden, daß kein Gerät die gleiche ID hat.
Verified that all the SCSI IDs were unique.
Stellen Sie sicher, dass alle SCSI-IDs nur einmal vorkommen.
Verify that all the SCSI IDs are unique.
Stellen Sie sicher, dass alle SCSI-IDs nur einmal vorkommen.
Look at the list of SCSI IDs on each channel to see which channels have devices attached.
Beachten Sie die Liste der SCSI-IDs auf jedem Kanal, um festzustellen, an welchen Kanälen Geräte angeschlossen sind.
Record which SCSI IDs are populated.
Notieren Sie die belegten SCSI-IDs.
The last device (drive) at the end of a SCSI bus must be properly terminated to allow the adapter to recognize the SCSI IDs of all the installed devices.
Das letzte Gerät (Laufwerk) am Ende eines SCSI-Busses muss korrekt mit einem Abschlusswiderstand versehen sein, damit der Adapter alle SCSI-IDs der installierten Geräte erkennen kann.
If the system uses a SCSI cable connected directly to the devices, you need to manually set the SCSI IDs during installation.
Wenn das System ein SCSI-Kabel verwendet, das direkt mit den Geräten verbunden wird, müssen Sie die SCSI-IDs während der Installation manuell festlegen.
If you have 8-bit SCSI peripherals, they must use SCSI IDs 0, 1, 2, 3, 4, 5, or 6.
Bei 8-Bit-SCSI-Peripheriegeräten müssen die SCSI-IDs 0, 1, 2, 3, 4, 5 oder 6 verwendet werden.
If your cluster hardware includes a SCSI bus, be sure to review carefully any instructions about termination of the SCSI bus and configuration of SCSI IDs.
Wenn Ihre Clusterhardware über einen SCSI-Bus verfügt, lesen Sie alle Anweisungen bezüglich der Terminierung des SCSI-Busses und der Konfiguraion von SCSI-IDs.
Cause: The SCSI IDs are not properly configured.
Ursache: Die SCSI-IDs wurden nicht ordnungsgemäß konfiguriert.