Use a soldering tool to connect the microcontroller, moisture sensor and wires.
Nutzen Sie einen Lötkolben, um Mikrocontroller und Feuchtigkeitssensor miteinander zu verdrahten.
As a human you will not notice this but the Microcontroller is so fast that it would see on, off, on, off...
It seems however easier to wake up the Microcontroller from "idle mode".
The software for the Microcontroller sets up 2 counters in interrupt mode.
If this test works then you can be sure that the Microcontroller will work.
Wenn das Testprogramm funktioniert, dann kann man sicher sein, dass der Microcontroller funktioniert.
The software for the Microcontroller uses many aspects which you already know from the previous articles (uart for rs232, lcd display, counters in interrupt mode).
Die Software für den Mikrocontroller benutzt viele Dinge, die wir schon aus früheren Artikeln kennen (uart für rs232, LCD Treiber, Zähler im Interruptmode).
The protocol of the serial bus including clock and collision detection is coded in the firmware of the Microcontroller.
Das gesamte Protokoll und auch der Takt sowie die Kollisionserkennung erfolgt in der Firmware des Controllers.
The main loop first checks the analog values of the photo-resistors by running the Microcontroller's internal analog to digital converter in single shot conversion mode 3 times.
Die Hauptschleife überprüft zuerst die analogen Werte der Fotowiderstände durch dreimaliges Laufenlassen des internen analog zu digital Umwandlers des Microcontrollers in single shot Conversionsmode.
Instead, the Microcontroller of the adapter deals with the bus communication, while on the PC side a terminal-program as used for modems is sufficient.
Vielmehr kümmert sich der Microcontroller des Adapters um die Kommunikation mit der Floppy, während auf PC-Seite nur ein Terminal-Programm, wie es für Modems üblich ist, benötigt wird.
Use a voltmeter and check that you have +5V on the max232 between pin 8 and 16 and on the Microcontroller pins 7 and 8.
Plus an Pin 2, Minus an Pin 1. Nimm ein Voltmeter und prüfe, dass du +5V an dem max232 zwischen 8 und 16 hast und an dem Mikrocontroller Pin 7 und 8. An den OPs sollten fast 9V liegen.
The 16bit wide counter (pin PD5 on the Microcontroller) gets its pulse signals from the signal that we want to measure.
Der 16bit Zähler (Pin PD5 am Microcontroller) erhält seine Pulse über das Signal, das wir messen wollen.
The only heat-sensitive components are the Microcontroller (packaged in antistatic bags) and the LED.
Die einzigen Hitzempfindlichen Teile sind der Mikrocontroller (eingepackt in antistatischer Folie) und die LED.
These binaries support one CAN interface of the Microcontroller.