Vertaling van "the clnode" in Frans
We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
Use the clnode rename command to rename the node.
For a global cluster, use the clnode status command with the -m option.
Pour un cluster global, utilisez la commande clnode status avec l'option -m.
You can also use the clnode evacuate and shutdown commands to shut down a zone-cluster node.
Vous pouvez également utiliser les commandes clnode evacuate et shutdown pour fermer un noeud du cluster de zones.
If such errors occur, add the -F option to the clnode remove command.
To put a node into maintenance state, the node must be shut down with the clnode evacuate and cluster shutdown commands.
Pour mettre un noeud en mode de maintenance, ce dernier doit être arrêté à l'aide des commandes clnode evacuate et cluster shutdown.
Shut down the cluster node gracefully by using the clnode evacuate command, then the shutdown command.
Arrêtez le noeud du cluster de manière appropriée à l'aide de la commande clnode evacuate, puis de la commande shutdown.
You can also run the clnode command instead of the clsetup utility to change the private hostname.
Vous pouvez également exécuter la commande clnode au lieu de l'utilitaire clsetup pour changer le nom d'hôte privé.
Use the clnode command with the show-rev -v -node subcommand and option.
Utilisez la commande clnode avec la sous-commande et l'option show-rev -v -node.
Troubleshooting If the cluster node that you are removing is at least partially configured with the cluster, running the clnode remove command might exit with errors such as Node is still enabled.
Si le noeud de cluster que vous souhaitez supprimer est partiellement configuré avec le cluster, l'exécution de la commande clnode remove peut générer des erreurs, comme la sortie Node is still enabled (Le noeud est toujours activé).
Ensure that you successfully complete Step 4 in the procedure before you rerun the clnode remove command.
Assurez-vous d'avoir terminé l'Étape 4 de cette procédure avant d'exécuter à nouveau la commande clnode remove.
Note - To unconfigure the node but leave Oracle Solaris Cluster software installed on the node, do not proceed further after you run the clnode remove command.
Remarque - Pour annuler la configuration du noeud mais laisser le logiciel Oracle Solaris Cluster installé sur le noeud, ne continuez pas après l'exécution de la commande clnode remove.
To check the status of the IP Network Multipathing groups, use the command with the clnode status command.
Pour vérifier le statut des groupes IPMP (IP Network Multipathing), utilisez la commande clnode status.
The clnode remove command is run in noncluster mode from the node you want to remove from the cluster (phys-schost-2).
La commande clnode remove est exécutée en mode non cluster depuis le noeud à supprimer du cluster (phys-schost-2)