We konden deze vermelding niet vinden. Er worden benaderende resultaten weergegeven. Controleer je spelling of stel voor deze term aan het woordenboek toe te voegen.
Description This JR data cable is used to connect the telemetry output of the receiver to the FlightCtrl.
Description Ce câble JR permet de connecter la FlightCtrl à la sortie télémétrique du récepteur.
IMPORTANT The Nick- and Roll axis refers to the FlightCtrl, and not on the Mixer you use!
IMPORTANT Les axes de roulis et de tangage se réfèrent à la FC, et non pas à la table de mixage !
The NaviCtrl with the integrated compass could be also used single with the FlightCtrl.
La NaviCtrl2.0 avec son module compas intégré, peut également être utilisée individuellement avec la FlightCtrl.
The Shuttercable can be connected to one of the transistor outputs of the FlightCtrl through a switch operated via a servo output, the optocoupler part of this shutter, our Multifuntions Camera control board or our StratoSnapper 2.
Le câble de commande peut-être connecté à une des sorties de la FlightCtrl à travers un interrupteur pour sortie servo ou la partie optocoupleur de ce déclencheur, lié à un interrupteur de votre radiocommande.
with connection to FC2.1 Therefore the MK-USB must be connected to the FlightCtrl!
Pour cela le MK-USB doit être relié directement à la FlightCtrl !
then the KopterTool Version is not compatible to the software version on the FlightCtrl and/or NaviCtrl.
C'est que votre version de MKTool n'est pas compatible avec le firmware installé sur la FlightCtrl et/ou la NaviCtrl.
Signal beeps If the NaviCtrl (with Compass/MKGPS) is properly connected the FlightCtrl beeps more often.
Si la NaviCtrl (avec Compass/MKGPS) est correctement connectée, la FlightCtrl "bip" plus souvent.
This board is directly used as roll and nick gyro in the FlightCtrl ME.
Cette platine est utilisée comme gyroscope pour le roulis ou le tangage sur le FlightCtrl ME.
So for example if you try to program the NaviCtrl firmware into the FlightCtrl, it will give you an error message.
Donc par exemple, si vous essayez de charger la FlightCtrl avec le firmware de la NaviCtrl, vous obtiendrez un message d'erreur.
Depending on whether the Kopter is connected to the FlightCtrl or when using the GPS system on the NaviCtrl, the startup screen should look like this
Selon que le MK est raccordé via la FlightCtrl ou en cas d'installation du GPS via la NaviCtrl, l'écran resemblera à l'une ou l'autre de ces captures
The Shuttercable is simply connected to one of the transistor outputs of the FlightCtrl. Connection information
The alarm of the FlightCtrl sends a charge alert at a voltage of 3,3V (adjustable in the KopterTool, but please not below 3,3V!
L'alarme de la FlightCtrl déclenchera le buzzer lorsque le seuil de 3,3V sera atteint (Ce seuil est réglable dans KopterTool, Mais SVP jamais en dessous de 3,3V!
Potentieel gevoelige of ongepaste informatie
Er worden alleen voorbeelden gegeven om u te helpen het woord of de woordcombinatie waarop u hebt gezocht, te vertalen. Deze worden niet door ons geselecteerd of gevalideerd en kunnen ongepaste taal bevatten. Wij vragen u melding te maken van voorbeelden die dienen te worden aangepast of verwijderd. Vertalingen met grof of informeel taalgebruik worden meestal rood of oranje gemarkeerd.