Traduction de "SP-A" en coréen
Nous n’avons pas trouvé cette entrée. Affichage de résultats approximatifs. Vérifiez l’orthographe ou proposez d’ajouter ce terme au dictionnaire.
The network settings were already established for SP-A. If any changes are necessary, enter the correct settings.
SP-A 에 대한 네트워크 설정이 이미 구성되어 있습니다. 변경이 필요한 경우에는 해당 설정을 입력합니다.
In this exercise you will be using an Ethernet connection to SP-A.
이 실습에서는 SP-A 에 대한 이더넷 연결을 사용합니다.
Install the image on SP-A only.
SP-A 에만 이미지를 설치합니다.
Assign it to SP-A.
SP-A 에 할당합니다.
You can now establish the network settings for SP-A. Enter the following in the appropriate field
이제 SP-A 에 대한 네트워크 설정을 구성할 수 있습니다. 해당 필드에 다음을 입력합니다.
In this exercise, you will establish the network settings for SP-A and SP-B.
이 실습에서는 SP-A 및 SP-B 에 대한 네트워크 설정을 구성합니다.
Connect another cable from the second HBA to SP-A, port 1.
다른 HBA 와 SP-A, 포트 1 사이에 또 다른 케이블을 연결합니다.
Close your browser, then disconnect the serial cable from SP-B and reconnect it to the serial port on SP-A. (Wait for SP-B to finish rebooting before continuing.)
브라우저를 닫은 다음 SP-B 에서 직렬 케이블의 연결을 해제하고 SP-A 의 직렬 포트에 다시 연결합니다. SP-B 의 재부팅이 완료될 때까지 기다린 후 계속합니다.
Follow these steps to complete the configuration of both SP-A and SP-B properties.
다음 단계를 수행하여 SP-A 및 SP-B 속성을 구성합니다.
Initially, the only Storage Processor that can be set as the storage domain master is the first Storage Processor you configured using the serial connection session earlier (which in this instance is SP-A).
처음에 스토리지 도메인 마스터로 설정할 수 있는 유일한 스토리지 프로세서는 이전에 직렬 연결 세션을 사용하여 구성했던 첫 번째 스토리지 프로세서입니다. 이 경우에는 SP-A 입니다.
From your switch connect a FC cable to an unused port on SP-A of the other CX600 in the same cabinet as yours.
스위치의 FC 케이블을 동일한 캐비닛의 다른 CX600 의 SP-A 에 있는 사용하지 않는 포트에 연결합니다.
The same IP address is used for both SP-A and SP-B serial ports.
SP-A 및 SP-B 직렬 포트에는 동일한 IP 주소가 사용됩니다.
Follow these steps to establish a PPP session to SP-A and SP-B over a direct serial connection.
다음 단계를 수행하여 직접 직렬 연결을 통해 SP-A 및 SP-B 에 대한 PPP 세션을 설정합니다.