Exemples avec "add a disk array enclosure" et leurs traductions en coréen
Nous n’avons pas trouvé cette entrée. Affichage de résultats approximatifs. Vérifiez l’orthographe ou proposez d’ajouter ce terme au dictionnaire.
For example, to add a disk array enclosure above the SPE you just installed, refer to.
예를 들어 방금 설치한 SPE에 디스크 어레이 엔클로저를 추가하려면 를 참조하십시오.
This document describes how to add a disk array enclosure (DAE-AX) to an existing AX4-5 dual-SP system.
이 문서에서는 기존의 AX4-5 이중 SP 시스템에 디스크 어레이 엔클로저(DAE-AX)를 추가하는 방법을 설명합니다.
Autres résultats
Supports three add on disk array enclosure for a total of 60 drives in the storage array
스토리지 어레이에서 총 60개의 드라이브에 대해 3개의 애드온 디스크 어레이 엔클로저를 지원합니다.
Enter the IP address of an SP in the storage system to which you want to add a disk-array enclosure, and click Connect.
디스크 어레이 엔클로저를 추가할 스토리지 시스템에 있는 SP의 IP 주소를 입력하고 Connect 를 클릭합니다.
Supports up to 16 add on disk array enclosures for a total of 240 drives in the storage array.
스토리지 어레이에 총 240개의 드라이브가 탑재된 경우 최대 16개의 추가 디스크 어레이 케이스 지원.
To add a disk-array enclosure (DAE) to a storage system, you must use the Disk-Array Enclosure Installation wizard.
스토리지 시스템에 DAE(디스크 어레이 엔클로저)를 추가하려면 디스크 어레이 엔클로저 설치 마법사를 사용해야 합니다.
This wizard determines if you can add a disk-array enclosure to your storage system, and if you can, it recommends a bus and enclosure address for the enclosure and tells you how to install and cable the enclosure.
이 마법사는 디스크 어레이 엔클로저를 스토리지 시스템에 추가할 수 있는지 확인하고, 추가할 수 있는 경우 추가 엔클로저에 대해 사용할 수 있는 버스 및 엔클로저 주소를 알려주며 엔클로저를 설치하고 케이블로 연결하는 방법을 알려줍니다.
Describes how to use the disk-array enclosure installation utility to add a DAE2, DAE2P, or DAE3P disk-array enclosure to your storage system.
스토리지 시스템에 DAE2, DAE2P 또는 DAE3P 디스크 어레이 엔클로저를 추가하기 위해 필요한 디스크 어레이 엔클로저 설치 유틸리티의 사용법에 대해 설명합니다.
To add DAE3P enclosures to a newly initialized CX3-20f storage system, use the Install Disk Array Enclosure wizard in the Navisphere Service Taskbar or use the DAE setup guide located on the CX3-series documentation CD.
새로 초기화한 CX3-20f 스토리지 시스템에 DAE3P 엔클로저를 추가하려면 Navisphere Service Taskbar에 있는 디스크 어레이 엔클로저 설치 마법사를 사용하거나 CX3 UltraScale 시리즈 설명서 CD에 있는 DAE 설치 가이드의 지침을 따릅니다.
To add a DAE2, DAE2P, or DAE3P disk-array enclosure to a CX3 UltraScale [amp]trade; series or CX series storage system, you must use the disk array enclosure installation utility.
DAE2, DAE2P 또는 DAE3P 디스크 어레이 엔클로저를 CX3 UltraScale [amp]trade; 시리즈 또는 CX 시리즈 스토리지 시스템에 추가하려면 디스크 어레이 엔클로저 설치 유틸리티를 사용해야 합니다.
The storage array can house up to 15 3.5-inch SAS or SATA disk drives, and you can add capacity using up to two PowerVault MD1000 expansion enclosures, for a total of 45 disk drives.
스토리지 어레이는 최대 15개의 3.5인치 SAS 또는 SATA 디스크 드라이브를 장착할 수 있으며, 최대 2개의 PowerVault MD1000 확장 인클로저를 사용하여 총 45개의 디스크 드라이브 용량을 추가할 수 있습니다.
You can add another disk array enclosure to expand capacity.
단순히 다른 디스크 어레이 엔클로저를 하나 더 추가하면 됩니다.
In this case, your service provider must install any disk-array enclosures that you want to add to your storage system.
이 경우 서비스 공급업체에서 스토리지 시스템에 추가할 모든 디스크 어레이 엔클로저를 설치해야 합니다.
Contenu potentiellement sensible ou inapproprié
Les exemples vous aident à traduire le mot ou l’expression cherchés dans des contextes variés. Ils ne sont ni sélectionnés ni validés par nous et peuvent contenir des mots ou des idées inappropriés. Signalez des exemples à modifier ou à retirer. Les traductions potentiellement sensibles, inappropriées ou familières sont généralement marquées de rouge ou d’orange.