Nous n’avons pas trouvé cette entrée. Affichage de résultats approximatifs. Vérifiez l’orthographe ou proposez d’ajouter ce terme au dictionnaire.
RAID BIOS
F6 and RAID BIOS configurations need to be performed prior to installation of this driver for proper operation.
F6 및 RAID BIOS 구성은 올바른 작동을 위해이 드라이버를 설치 하기 전에 수행 해야 합니다.
The driver should be installed after the operating system has been installed. F6 and RAID BIOS configurations need to be performed prior to installation of this driver for proper operation.
드라이버는 운영 체제 설치 전에 설치해야 합니다. f6 및 RAID BIOS 구성의 올바른 작동을 위해 이 드라이버를 설치하기 전에 수행해야 합니다.
F6 and RAID BIOS configurations need to be performed prior to installation of this driver for proper operation.
적절한 작동을 위해 이 드라이버를 설치하기 전에 F6 및 RAID BIOS 구성을 수행해야 합니다.
F6 and RAID BIOS configurations need to be performed prior to installation of this driver for proper operation.
이 드라이버를 설치 하기 전에 F6 및 RAID BIOS 구성을 수행 해야 제대로 작동 합니다.
After the firmware upgrade, reboot the system and login to RAID BIOS Console.
펌웨어 업그레이드 후 시스템을 재부팅하고 RAID BIOS 콘솔로 로그인합니다.
Most controller (referred to as adapter in the software consoles) options can only be set by using the Intel RAID BIOS Console.
대부분의 컨트롤러(소프트웨어 콘솔에서는 어댑터로 칭함) 옵션은 인텔 RAID BIOS 콘솔을 사용해서만 설정이 가능합니다.
In order to determine if both drives are detected by the RAID BIOS (OROM), perform the following steps
두 드라이브가 RAID BIOS(OROM)에서 인식되는지 확인하려면 다음 단계를 수행하십시오.
Activate Intel RAID BIOS Console 2 Utility by pressing - during server boot up
서버 부팅 도중 -를 눌러서 인텔 RAID BIOS 콘솔 2 유틸리티를 활성화합니다.
With BIOS 10.x or later versions, the user is unable to enter the SATA embedded RAID BIOS console to configure an array.
BIOS 10.x 이상 버전을 사용하는 경우 사용자가 어레이를 구성하기 위해 SATA 내장 RAID BIOS 콘솔을 시작할 수 없습니다.
Because of this issue, the non-expander will not be displayed in the RAID BIOS Console and RAID Web Console 2; and the physical drive locating functionality is inoperable.
이 문제로 인해 RAID BIOS 콘솔과 RAID 웹 콘솔 2에 비-확장기가 표시되지 않으며 물리적 드라이브 위치 지정 기능이 작동하지 않습니다.
Upon re-boot you will see the Intel RAID BIOS status message on the screen - press CTRL-I to enter the Intel? RAID Option ROM user interface.
다시 부팅할 때 화면에 인텔 RAID BIOS 상태 메시지가 표시되면 CTRL-I를 눌러 인텔 RAID 옵션 ROM 사용자 인터페이스로 들어갑니다.
Checked to see if both drives were detected in the RAID BIOS.
RAID BIOS에서 드라이브가 모두 인식되는지 확인했습니다.
Contenu potentiellement sensible ou inapproprié
Les exemples vous aident à traduire le mot ou l’expression cherchés dans des contextes variés. Ils ne sont ni sélectionnés ni validés par nous et peuvent contenir des mots ou des idées inappropriés. Signalez des exemples à modifier ou à retirer. Les traductions potentiellement sensibles, inappropriées ou familières sont généralement marquées de rouge ou d’orange.